Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
lab05_en:inverting_op-amp_basics_amplification [2026/04/01 17:30] – mexleadminlab05_en:inverting_op-amp_basics_amplification [2026/04/28 16:21] (current) – [Analysis of inverting input currents] mexleadmin
Line 19: Line 19:
 \\ \\
 $U_{\rm IN}{\rm~=}$ $U_{\rm IN}{\rm~=}$
-\\ 
-\\ 
-\\ 
 \\ \\
 \\ \\
Line 43: Line 40:
 \\ \\
 \\ \\
-== Investigation of inverting input ==+== Analysis of inverting input currents ==
 \\ \\
 \\ \\
 {{drawio>lab05:Fig-30_inverting_op-amp_inv_input.svg}} {{drawio>lab05:Fig-30_inverting_op-amp_inv_input.svg}}
 \\ \\
-<imgcaption Fig-30_inverting_op-amp_inv_input | Inverting Op-Amp: Investigate inverting input> </imgcaption>+<imgcaption Fig-30_inverting_op-amp_inv_input | Inverting Op-Amp: Analysis of currents of the inverting input> </imgcaption>
 \\ \\
 \\ \\
 $U_{\rm DD}{\rm~=10~V},~U_{\rm SS}{\rm~=-10~V},~R_{\rm 1}{\rm~=10~k\Omega}$\\ \\ $U_{\rm DD}{\rm~=10~V},~U_{\rm SS}{\rm~=-10~V},~R_{\rm 1}{\rm~=10~k\Omega}$\\ \\
-For  $U_{\rm IN},~U_{\rm OUT},~R_{\rm 2}$  use the values from <imgref Fig-20_inverting_op-amp>. +Use the values from <imgref Fig-20_inverting_op-amp> for $U_{\rm IN},~U_{\rm OUT},~R_{\rm 2}$.
-\\+
 \\ \\
 \\ \\
 Complete the arrows in the scematic of the circuit.\\ Complete the arrows in the scematic of the circuit.\\
-Determine the the currents $I_{\rm 1}$ and $I_{\rm 2}$ indirectly through a voltage measurement.\\ +Determine the the currents $I_{\rm 1}$ and $I_{\rm 2}$ indirectly by measuring the voltage across known resistors\\ 
-Calculate the sum of the currents at node ${\rm N_{12}}$.+and calculate the algebraic sum of the currents at node $N_{\rm {12}}$ using Kirchhoff’s Current Law (KCL). 
 +\\ 
 +\\ 
 +$U_{\rm 1}{\rm~=}$ 
 +\\ 
 +\\ 
 +\\ 
 +$U_{\rm 2}{\rm~=}$\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\ 
 +\\
 \\ \\
 \\ \\
Line 111: Line 128:
 \\ \\
 \\ \\
- +== Analysis of inverting input voltages == 
-- Virt masse messen\\ +\\ 
-- r2 kurzschluss+\\ 
 +\\ 
 +{{drawio>lab05:Fig-40_inverting_op-amp_inv_input_virt_gnd.svg}} 
 +\\ 
 +\\ 
 +<imgcaption Fig-40_inverting_op-amp_inv_input_virt_gnd | Inverting Op-Amp: Analysis of virtual GND of the inverting input> </imgcaption> 
 +\\ 
 +\\ 
 +$U_{\rm DD}{\rm~=10~V},~U_{\rm SS}{\rm~=-10~V},~R_{\rm 1}{\rm~=10~k\Omega}$\\ \\ 
 +Use the values from <imgref Fig-20_inverting_op-amp> for $U_{\rm IN},~U_{\rm OUT},~R_{\rm 2}$. 
 +\\ 
 +\\ 
 +\\ 
 +Complete the reference arrows in the scematic of the circuit.\\ 
 +Take the values for $U_{\rm 1},~U_{\rm 2},~U_{\rm OUT}$ from <imgref Fig-30_inverting_op-amp_inv_input>.\\ 
 +Calculate the voltage $U_{12}$ using Kirchhoff's Voltage Law (KVL) within the circuit loop.\\ 
 +Verify your calculated result by measuring $U_{12}$. 
 +\\ 
 +\\ 
 +\\ 
 +$U_{\rm 1}{\rm~=}$ 
 +\\ 
 +\\ 
 +\\ 
 +$U_{\rm 2}{\rm~=}$ 
 +\\ 
 +\\ 
 +\\ 
 +$U_{\rm OUT}{\rm~=}$ 
 +\\ 
 +\\ 
 +\\ 
 +Calculated $U_{\rm 12}{\rm~=}$ 
 +\\ 
 +\\ 
 +\\ 
 +Measured $U_{\rm 12}{\rm~=}$ 
 +\\ 
 +\\ \\ 
 +Analyse the physical significance of the potential at $N_{12}$ relative to GND (defined as $U_{12}$) in the context of the operational amplifier's input configuration. What do you observe?\\ 
 +\\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +\\ 
 +What happens if you short-circuit $R_2$ (the feedback resistor)?\\ 
 +Experimentally verify this effect and explain the observed behavior regarding the output voltage.\\ 
 +\\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\ 
 +${\rm ................................................................................................}$ \\ \\